Baby Yoda Hot Cocoa Bombs make you the coolest cup of hot chocolate in the entire galaxy. If you are looking for a fun and tasty way to make hot cocoa, this is the way!
Place about ½ cup of the bright green candy melts aside for baby Yoda’s ears.
Melt the remaining candy melts in increments of 30 seconds using a microwave safe bowl. Stir and repeat until the chocolate is melted.
Using a spoon, spoon about 1-2 tbsp of the candy melts into the silicone mold.
Carefully swirl the candy melt to completely coat the inside of each cavity of the mold.
Lightly shake the extra candy melt back into the bowl.
Place the coated molds into the fridge for 5-10 minutes until hardened.
Remove from the fridge and gently peel the silicone mold back away from the hardened shell
Carefully place the mold onto the cookie sheet. You should have 8 halves depending on what size of silicone mold you are using.
How to Make The Baby Yoda Chocolate Ears
Draw a Baby Yoda silhouette and cut it out. You will be sticking this under your wax paper to outline it in chocolate.
Melt the candy melts that was set aside in increments of 30 seconds until melted.
Scoop the melted candy melts into the piping bag and lay a piece of wax paper over the outline of Baby Yoda.
Using the piping bag, pipe an outline of Baby Yoda’s ears and then fill in the ears using the green chocolate.
Repeat about 8-10 times that way you have extra incase an ear breaks when you build the cocoa bomb.
Place the tray into the fridge and allow to harden.
Now you can begin building the hot cocoa bombs.
How to Assemble The Baby Yoda Hot Cocoa Bombs
Place 4 molds onto the large cookie sheet and place the small pan onto a stove top over low-medium heat (you can also make a hot plate using the microwave)
Scoop about 1 ½ tablespoons of cocoa powder into the bottom mold and place a small handful of mini marshmallows into the mold.
Carefully place the top mold onto the pan or hot plate to melt the edge for a quick few seconds
Quickly place the mold onto the top of the bottom mold and gently press down
Allow the candy melt to harden together to seal the seam.
Remove the ears from the fridge and carefully peel ears off the wax paper
Quickly melt the edge of the ears using the warm pan or hot plate then place the ears onto the sides of the mold
Using the piping bag, pipe squiggly lines for Baby Yoda’s forehead and allow the details to harden.
When ready to enjoy, serve up with a hot cup of milk!
Nutrition information is a rough estimate only; actual values will vary based on the exact ingredients used and amount of recipe prepared.